24 ldp hello-interval – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 483
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 483 of 855
25.24 ldp hello-interval
Use this command to set the interval for sending multicast Hello packets via an interface. Use the
no parameter with this command to revert to the hello-interval value set for the main LDP process.
Command Syntax
(no) ldp hello-interval number
Syntax Description
number
Specifies the interval in seconds, the range is 1 to 21845
Command Mode
Interface mode
Defaults
The default is 5 seconds.
Examples
In the following example, the ldp hello-interval command is used to set the interval for sending
multicast Hello packets via an interface:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ldp hello-interval 635
Related Commands
hello-interval
hold-time
ldp hold-time