17 switchport, 18 show management ip address – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 70
CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 70 of 855
4.17 switchport
Use this command to configure a port to a bridge (layer 2) or routing (layer 3) mode.
Use the no form of this command to reset the mode to the appropriate default for the device.
Command Syntax
switchport
no switchport
Command Mode
Interface configuration
Default
switchport
Usage
When using this command to change the mode of a port, all bridge or routing configurations of this port
will be cleared.
Examples
This example shows how to configure a port to bridge mode.
Switch(config-if)# switchport
This example shows how to configure a port to bridge mode.
Switch(config-if)# no switchport
Related Commands
None
4.18 show management ip address
Use this command to show the management ip address.
Command Syntax
show management ip address
Command Mode
EXEC
Usage
None
Examples