29 ldp targeted-peer-hello-interval – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 488
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 488 of 855
25.29 ldp targeted-peer-hello-interval
Use this command to set the interval for sending unicast hello packets to targeted peers via this
interface. Use the no parameter to revert to the targeted-peer hello-interval value set for the main
LDP process.
Command Syntax
(no) ldp targeted-peer-hello-interval number
Syntax Description
number
Specifies the interval in seconds, the range is 1 to 21845
Command Mode
Interface mode
Defaults
The default is 15 seconds.
Examples
In the following example, the ldp targeted-peer-hello-interval command is used to set the interval
for sending unicast hello packets to targeted peers via this interface:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ldp targeted-peer-hello-interval 635
Related Commands
show ldp interface IFNAME
targeted-peer-hello-interval