CANOGA PERKINS CanogaOS Command Reference - Manual (Page 225)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 225 of 855
Default
Built-in, automatic metric translations, as appropriate for each routing protocol.
Command Mode
Router configuration
Usage
The Default -metric command is used in conjunction with the redistribute router configuration
command to cause the current routing protocol to use the same metric value for all redistributed routes.
A default metric helps solve the problem of redistributing routes with incompatible metrics. Whenever
metrics do not convert, using a default metric provides a reasonable substitute and enables the
redistribution to proceed.
Examples
The following example shows a switch using both the RIP and the Open Shortest Path First (OSPF)
routing protocols. The example advertises OSPF-derived routes using RIP and assigns the
OSPF-derived routes a RIP metric of 10.
router rip
default-metric 10
redistribute ospf
!
Related Commands
redistribute (RIP)
14.3 distance (RIP)
To define an administrative distance for routes that are inserted into the routing table, use the distance
command in router configuration mode. To return the administrative distance to its default distance
definition, use the no form of this command.
Command Syntax
distance distance prefix/prefix-length [access-list-name]
no distance
distance Administrative distance. An integer from 1 to 255. (Routes with a
distance value of 255 are not installed in the routing table.)
prefix IP prefix for the originator of the imcoming routing updates.
prefix-length Prefix length for the originator.
access-list-name (Optional) Named access list to be applied to incoming routing
updates.