3 mpls-l2-circuit – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 589
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 589 of 855
29.3 mpls-l2-circuit
Use this command to bind an interface to a MPLS Layer 2 Virtual Circuit.
Command Syntax
mpls-l2-circuit NAME [ethernet | vlan VLANID]
Syntax Description
NAME
Identifying string for MPLS Layer-2 Virtual Circuit.
VLANID
Vlan identifier, the range should be from 1 to 4094.
Command Mode
Interface mode
Defaults
PW type is ethernet.
Examples
In the following example, the mpls-l2-circuit command is used to bind an interface to a MPLS
Layer 2 Virtual Circuit:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config)# mpls-l2-circuit pw1 vlan 100
Related Commands
no mpls-l2-circuit