CANOGA PERKINS CanogaOS Command Reference - Manual (Page 175)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 175 of 855
8.10 erps ring enable
Use this command to enable/disable specific erps ring instance.
Command Syntax
erps ERPS_ID ring RING_ID {enable | disable}
ERPS_ID: <1-255> ERPS domain ID
RING_ID: <1-255> ERPS ring ID
enable: enable the ring
disable: disable the ring
Command Mode
Global configuration
Usage
Upon the specific ERPS ring is enabled successfully, the ring state should leave the idle state.
Examples
This example shows how to enable ERPS domain 11 ring 1.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#erps 11 ring 1 enable
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 edge node mode: edge
ERPS ring 1 node state: link up
ERPS ring 1 edge interface name: eth-0-9
ERPS ring 1 common interface name: eth-0-13
EPRS ring 1 SRPT is disabled
Related Commands
None