17 show startup-config – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 738
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 738 of 855
The following example shows the configuration for serial interface 1:
Switch# show running-config interface eth-0-1
Building configuration...
Current configuration:
!
interface eth-0-1
no switchport
ip address 192.168.0.1/24
shutdown
end
Related Commands
configure terminal
show startup-config
39.17 show startup-config
To display the contents of the currently running configuration file or the configuration for a specific class
map, interface, map class, policy map, or routing protocols, use the show startup-config command in
privileged EXEC mode.
Command Syntax
show startup-config
Default
The show startup-config command without any arguments or keywords displays the entire contents
of the startup configuration file in flash:.
Command Mode
privileged EXEC
Usage
Examples
The following example shows the configuration for serial interface 1:
Switch# show startup-config
Building configuration...
Current configuration:
......
!
interface eth-0-1