CANOGA PERKINS CanogaOS Command Reference - Manual (Page 621)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 621 of 855
31.5 traceroute mpls l2-circuit
Use this command to initiate tracing the route traversed by the specified Layer-2 VC echo request
packet in the MPLS cloud.
Command Syntax
traceroute mpls l2-circuit VC_ID source A.B.C.D [destination A.B.C.D | detail | dsmap | flags |
interval INT_VAL | repeat REP_VAL | reply-mode MODE | timeout TIME_OUT | ttl TTL_VAL]
Syntax Description
VC_ID Layer-2 VC ID
source A.B.C.D Specifies the source address used in the echo request
packet.
destination
A.B.C.D Specifies a network 127/8 address to be used as the
destination address in the echo request packet.
detail Enables verbose output information, including MPLS echo
reply, sender address of the packet, and return codes.
dsmap Indicates that a downstream mapping (DSMAP) type
length and value should be included in the LSP echo
request.
flags Received LSR must do an FEC stack validation. Optional.
Default is disabled.
interval INT_VAL Specifies a send interval between requests (in
milliseconds). The range is from 2 to 20000.Default is 2.
repeat REP_VAL Specifies the number of times to resend a packet. The
range is from 1 to 5000. Default is 5.
reply-mode MODE Specifies the reply mode for the echo request packet.
z Reply with IP UDP packet (default)
z Reply with IP UDP packet with router alert
timeout
TIME_OUT Specifies the timeout interval in seconds. The range is
from 1 to 500. Default is 60.
ttl TTL_VAL Specifies the TTL value to be used in the MPLS labels.
The range is from 1 to 255. Default is 255.
Command Mode
Privileged Exec mode
Defaults
This command has no default settings.
Examples
In the following example, the traceroute mpls l2-circuit command is used to initiate tracing the