CANOGA PERKINS CanogaOS Command Reference - Manual (Page 554)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 554 of 855
28.1.1.4 Defaults
The permit keyword is the default.
28.1.1.5 Examples
The following example shows how to create a route-map and enter route-map
configuration mode:
Switch(config)# route-map rip-to-ospf permit
Switch(config-route-map)# match metric 1
Switch(config-route-map)# set metric 2
28.1.1.6 Related Commands
match as-path
match community
match interface
match ip address
match local-preference
match metric
match origin
match route-type
match tag
set aggregator
set as-path
set atomic-aggregate
set comm-list
set community
set dampening
set extcommunity
set ip address
set local-preference
set metric
set metric-type
set origin
set originator-id
set tag
set vpnv4
set weight
28.2 match as-path
Use this command to match an autonomous system path access list.
Use the no parameter with this command to remove a path list entry.