CANOGA PERKINS CanogaOS Command Reference - Manual (Page 203)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 203 of 855
11
Ethernet OAM Commands
Default Ethernet OAM Configuration
Ethernet OAM is disabled on all interfaces.
When Ethernet OAM is enabled on an interface, link monitoring is automatically turned on.
Remote loopback is disabled.
Restrictions for Ethernet OAM
For a remote failure indication, the switch does not generate Link Fault, Critical and Dying Gasp Event OAM
PDUs. However, if these PDUs are received from a link partner, they are processed.
The switch does not support Ethernet OAM on ports that belong to a Linkagg port.
11.1 ethernet oam enable
Use this command to enable Ethernet operations, maintenance, and administration (OAM) on an
interface.
Command Syntax
ethernet oam enable
no ethernet oam enable
Command Mode
Interface mode
Default
The default status of Ethernet OAM is disabled.
Usage
This command is used to enable the Ethernet OAM module on a port.
Examples
Switch#configure terminal
Switch(config)#interface eth-0-1
Switch(config-if)# ethernet cfm enable
Related Commands
no ethernet oam enable