CANOGA PERKINS CanogaOS Command Reference - Manual (Page 140)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 140 of 855
Switch# configure terminal
Switch(config)# spanning-tree pathcost-standard dot1d-1998
Related Commands
7.15 spanning-tree path-cost
Use this command to set the cost of a path associated with the default bridge-group. The lower the
path cost, the greater the likelihood of the bridge becoming root. Use the no parameter with this
command to calculate path cost according to interface’s speed.
Command Syntax
spanning-tree path-cost number
no spanning-tree path-cost
number The cost to be assigned to the group. The range is 1 to 200000000.
Command Mode
Interface mode
Default
The default path cost value is calculated according to interface’s speed.
Usage
The priority values can only be set in increments of 16.
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# spanning-tree path-cost 123
Related Commands
7.16 spanning-tree link-type
Use this command to enable or disable point-to-point or shared link types. Use the no parameter with
this command to disable rapid transition.
Command Syntax
spanning-tree link-type {auto | point-to-point | shared}
no spanning-tree link-type
auto Change link type according to interface’s duplex automatically.