17 spanning-tree edgeport – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 141
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 141 of 855
shared
Disable
rapid
transition.
point-to-point Enable
rapid
transition.
Command Mode
Interface mode
Default
The link type is auto detected.
Usage
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# spanning-tree link-type shared
Related Commands
7.17 spanning-tree edgeport
Use this command to set a port as an edge-port and to enable rapid transitions. Use the no parameter
with this command to set a port to its default state (not an edge-port) and to disable rapid transitions.
Command Syntax
spanning-tree edgeport
no spanning-tree edgeport
Command Mode
Interface mode
Default
Usage
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# spanning-tree edgeport
Related Commands