50 targeted-peer-hold-time – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 515
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 515 of 855
25.50 targeted-peer-hold-time
Use this command to set the time-out value that is the time that the router waits before rejecting an
adjacency with targeted peers. Use the no parameter to revert to the default targeted-peer hold-time
value.
Command Syntax
(no) targeted-peer-hold-time number
Syntax description
number
Specifies the interval in seconds, the range is 3 to 65535
Command Mode
Router mode
Defaults
The default is 45 seconds.
Examples
In the following example, the targeted-peer-hold-time command is used to set the time-out value
that is the time that the router waits before rejecting an adjacency with targeted peers:
Switch# configure terminal
Switch(config)# router ldp
Switch(config-router)# targeted-peer-hold-time 100
Related Commands
show ldp
ldp targeted-peer-hold-time