15 vlan dot1q tag native, 16 show dot1q ethertype – CANOGA PERKINS CanogaOS Command Reference User Manual
Page 186
CanogaOS Command Line Reference
Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches
Page 186 of 855
Use this display current l2 protocol tunnel configuration or on specified interface.
Examples
Switch # show l2protocol-tunnel interface eth-0-1
Interface Protocol Operation
=========== =========== ============
eth-0-1 stp Tunnel
Related Commands
9.15 vlan dot1q tag native
Use this command to enable tagging all native vlan.
Command Syntax
vlan dot1q tag native
no vlan dot1q tag native
Command Mode
Global configuration
Usage
Use this command to enable tagging native. By default, native vlan should untagged when packet
sending out of port.
Examples
Switch(config)# vlan dot1q tag native
Related Commands
None
9.16 show dot1q ethertype
Use this command to display dot1q ethertype.
Command Syntax
show dot1q ethertype [interface IFNAME]
IFNAME: 802.1q interface configuration
Command Mode
Privileged EXEC
Usage
None
Examples