IDEC High Performance Series - Manual (Page 1023)

WindO/I-NV2 User’s Manual 21-3
2 Sound Function Configuration Procedure
21
Sound F
unction
4 Double click the cell under Save To and select the save destination for the sound file.
■ Int. Memory
Saves the sound file to internal memory.
■ Memory Card
Saves the sound file to memory card inserted in the MICRO/I.
5 Double click the cell under Trigger Condition and select Device Address.
6 Specify the device address that will trigger playing the sound file in Trigger Device.
Double click the cell under Trigger Device or click to display the Device Address Settings dialog box. For
the device address configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
7 Configure Repeat, Change Volume Level, and any other options, and then click OK.
The Sound Settings dialog box closes.
This concludes the configuration to play a sound file when a device changes to 1.
●
To play a sound file as a touch sound instead of a beep.
1 On the Configuration tab, in the System Setup group, click Sound.
The Sound Settings dialog box is displayed.
2 Select the ID’s row to register the sound file to and click (import sound file).
The Open dialog box is displayed.
The procedures to write the sound file to the memory card are as follows.
• On the Home tab, click the arrow under Download, and click Project Data to display the Download
dialog box. Select the Download Sound Files to Memory Card check box and click OK.
• On the Home tab, click the arrow under Download, and click Data to Memory Card to display the
Open dialog box. Specify a sound file and click Open.