1 bar chart – IDEC High Performance Series User Manual
Page 682
1 Bar Chart
11-10
WindO/I-NV2 User’s Manual
■
When Data Over
These options configure the operation of the part when the allowable range is exceeded.
These options can only be configured when the Minimum or Maximum check boxes are selected under Range.
Example: If the word device value of the reading source is “110” which is higher than the upper limit of “100” ,or
“-10” which is below the lower limit of “0”, a value of 1 will be written to LM0 and the displayed bar will
flash.
Flash:
Select this check box to make the chart flash when the displayed data exceeds the allowable range.
Report:
Select this check box to write 1 in the report device when the displayed data exceeds the allowable
range.
Report Device: Specifies the report device.
Click
to display the Device Address Settings dialog box. For the device
address configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on
page 2-67.
Ch1 data
60
Ch2 data
Ch1
Ch2
10
1
0
0
1
Display
20
110
50
80
10
-10
Flashing
Flashing
Range: Value
Minimum: 0
Maximum: 100
When Data Over
Flash
Report
DesƟnaƟon Device: LM0
Data over noƟficaƟon: LM0
100
50
0
100
50
0
100
50
0
100
50
0