IDEC High Performance Series - Manual (Page 219)

WindO/I-NV2 User’s Manual 4-33
3 Project Settings Dialog Box
4
Project Set
tings
+1
2
Flash display
(0.5 sec. cycle)
This bit stores the screen flash state (0.5 sec. cycle). Write a value to
this bit to change the state. This bit is 0 immediately after the power
is turned on.
0: Do not flash
Stop flashing the screen and turn it on.
1: Flash
Flashes the screen in 0.5 second intervals.
When flash display (1 sec. cycle) (address+1, bit 1) and flash
display (0.5 sec. cycle) (address+1, bit 2) are both 1, the
screen flashes at one second intervals.
3 to 4 Reserved
5 Backlight auto off
This bit stores whether or not the function to automatically turn off
the backlight is enabled when the Auto OFF check box is selected
under Backlight in the Project Settings dialog box. Write a value
to this bit to change the state. This bit is 0 immediately after the
power is turned on.
0: Enabled
Automatically turns off the backlight when the MICRO/I is
unused for an extended period of time.
1: Disabled
Does not automatically turn off the backlight when the
MICRO/I is unused for an extended period of time. The
backlight turns on if the value changes to 1 when the backlight
is off.
6 Beep
This bit stores the beep state. Write a value to this bit to change the
state. This bit is 0 immediately after the power is turned on.
0: Stop
Stops continuous beeping.
1: Beep
Starts continuous beeping.
7 Screen display
This bit stores the screen display state. Write a value to this bit to
change the state.
0: Hide
Hides the screen when the backlight is on.
1: Show
Displays the screen.
8 Reserved
9 Clear error
Write 1 to this bit to clear the error information bit (System Area 2,
address+2). This bit automatically changes to 0 when processing is
finished.
10
Numerical input setting
clear
Write 1 to this bit to clear the numerical input setting complete bit
(System Area 2 address+3, bit 0) and the numerical input setting
cancel bit (System Area 2 address+3, bit 1). This bit automatically
changes to 0 when processing is finished.
11 Character input setting clear
Write 1 to this bit to clear the character input setting complete bit
(System Area 2 address+3, bit 5) and the character input setting
cancel bit (System Area 2 address+3, bit 6). This bit automatically
changes to 0 when processing is finished.
12 to 15 Reserved
Address Bit Function Description