IDEC High Performance Series - Manual (Page 595)

WindO/I-NV2 User’s Manual 10-83
5 Message Display
10
Data Displa
ys
• When the Change Color by Device check box is selected
The colors that correspond to the values stored in the device addresses for Change Color by Device and the this
device address + 1 are alternately displayed.
Enable: Selects this check box to make text color and plate color flash.
Trigger Device: Specifies the bit device or word device that will be used as a condition to trigger flash.
Click to display the Device Address Settings dialog box. For the device address
configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
Flash intervals are set in the Flashing Cycle on the System tab in the Project Settings dialog
box.
Text Color: Selects the color (color: 256 colors, monochrome: 16 shades) of text when flashing.
Click this button to display the Color Palette. Select a color from the Color Palette.
This option can only be configured when the Change Color by Device check box is cleared.
Plate Color: Selects the plate color (color: 256 colors, monochrome: 16 shades) when flashing.
Click this button to display the Color Palette. Select a color from the Color Palette.
This option can only be configured when the Change Color by Device check box is cleared and
Standard is selected for Image Type on the View tab.
HG SERIES
HG SERIES
Flashing
MICRO/I External device
HG SERIES
HG SERIES
Lower byte Upper byte
D0 0 x 1 4 0 x 1 6
Lower byte Upper byte
D1 0 x F 7 0 x 2 3
Text color Plate color
Text color
when flashing Plate color
when flashing
0
1
D0=
Lower byte Upper byte
0 x 1 4 0 x 1 6
D1= 0 x F 7 0 x 2 3
Trigger device
Device for Change Color by Device
+1