IDEC High Performance Series - Manual (Page 1326)

1 HG2G-S/-5S
34-10 WindO/I-NV2 User’s Manual
1.7 Installation
●
Operating Environment
For designed performance and safety of the HG2G-S/-5S, do not install the HG2G-S/-5S in the following environments:
• Where dust, briny air, or iron particles exist.
• Where oil or chemical splashes for long time.
• Where oil mist is filled.
• Where direct sunlight falls on the HG2G-S/-5S.
• Where strong ultraviolet rays fall on the HG2G-S/-5S.
• Where corrosive or combustible gasses exist.
• Where the HG2G-S/-5S is subjected to shocks or vibrations.
• Where condensation occurs due to rapid temperature change.
• Where high-voltage or arc-generating equipment (electromagnetic contactors or circuit protectors) exists in the
vicinity.
●
Ambient Temperature
• Allow sufficient space for ventilation, and install the equipment away from heat sources.
• Allow at least 100mm between the HG2G-S/-5S and walls or other equipment.
• Do not install the HG2G-S/-5S where the ambient temperature exceeds the rated operating ambient temperature
range. When mounting the HG2G-S/-5S in such locations, provide a forced air-cooling fan or air-conditioner to keep
the ambient temperature within the rated temperature range.
●
HG2G-S/-5S Installation
• Make a panel cut-out on the panel with the dimensions shown below.
• The HG2G-S/-5S has the mounting clip positions not only on the top and bottom side but also on the left and right
side. But when fasten with the attached mounting clips at the left and right side, the HG2G-S/-5S may impair the
waterproof, the vibration resistance, and the shock resistance characteristics.
CAUTION
• Do not tighten excessively, otherwise the HG2G-S/-5S may warp and cause wrinkle on the display,
or impair the waterproof characteristics.
• If the mounting clips are tightened obliquely to the panel, the HG2G-S/-5S may fall off the panel.
• When installing the HG2G-S/-5S into a panel cut-out, make sure that the gasket is not twisted.
Especially when re-installing, take special care because any twists in the gasket will impair the
waterproof characteristics.
B
A
A B Panel Cut-out
121.0
+2.0
0
153.0
+2.0
0
1.6 to 5.0
Panel
Mounting
Clip
HG2G
Unit : N•m
Type Specified Torque
HG2G-S 0.12 to 0.17
HG2G-5S 0.2 to 0.3