IDEC High Performance Series - Manual (Page 776)

6 Multi-Command
12-40 WindO/I-NV2 User’s Manual
6.3 Properties of Multi-Command Dialog Box
This section describes items and buttons in the Properties dialog box.
●
General Tab
■ Part Name
Enter a name for the part. The maximum number is 20 characters.
■ Multi-Functions
Add and edit commands to be executed when the trigger condition is satisfied.
Function List: Lists the commands to be executed.
Command Type: Shows the command type.
Command Name: Shows the command name.
Device: Shows the setting when one of the following Command Type is selected.
Shows the destination device for the Bit Write and Word Write commands.
Shows the screen number when Goto Screen is set to Switch to Base
Screen, Open Popup Screen, or Close Popup Screen.
Shows the script ID for the Script command.
• Executes only the Goto Screen command at the end of the Function List when multiple Switch to Base
Screen type commands are set for Action Mode.
• Goto Screen commands are not executed from top to bottom as they appear in the Function List.
Rather, they are executed at the end of the scan when the trigger condition is satisfied.
• Key commands are executed in the scan that follows a scan that satisfies the trigger condition.
• If multiple Key commands are set, only the first and second Key commands in the Function List are
executed. The third and following Key commands are not executed. Also, only the first Key command that
specifies a Data Transfer function in the Function List is executed if multiple Key commands are set.
Command Type: Select the command to add.
Bit Write: Writes a 0 or 1 to a bit device or bit of the word device. For details, refer to
“Properties of Bit Write for Multi-Functions dialog box” on page 12-42.
Word Write: Writes a value to a word device. Can be used to indirectly specify the
destination address or to perform operations on the written value. For details,
refer to “Properties of Word Write for Multi-Functions dialog box” on page 12-
43.