IDEC High Performance Series - Manual (Page 856)

3 Data Log Settings Dialog Box
14-18 WindO/I-NV2 User’s Manual
■ Clear Log Data *2
Select this check box to erase the Data Log data for the selected channel from the Data Storage Area.
*2 HG2G-S/-5S/-5F, HG3G/4G only
(Trigger device): Specifies the bit device or bit of the word device that triggers the erasure of the data. The data for
selected channels is erased when the value of the configured device changes from 0 to 1. For the
device address configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-
67.
If the amount of log data for the channel differs, the Line Chart cannot be displayed.
If differing channels of data were displayed in the same chart, the chart can no longer be displayed if the
Data Log data is erased by channel units.