IDEC High Performance Series - Manual (Page 459)

WindO/I-NV2 User’s Manual 8-135
8 Selector Switch
8
Bu
tton
s
Insert: Inserts a notch setting entry above the currently selected position.
Select the channel number from the list where you wish to insert the notch setting and click
Insert. This displays the Notch Settings dialog box where you can configure the notch. The
notch settings at the point of insertion shift down one line. Notch settings cannot be inserted if
all channel numbers have a notch setting.
Remove: Deletes the registered notch setting from the list.
Select the channel number in the list and click Remove.
Default Position: Selects the default position of the knob when the MICRO/I starts operation and the Selector
Switch is first displayed on the screen.
Ch1: Makes Ch1 the default knob position. Writes 1 to the device configured for Ch1,
writes 0 to the devices configured for the other channels.
Ch2: Makes Ch2 the default knob position. Writes 1 to the device configured for Ch2,
writes 0 to the devices configured for the other channels.
Ch3: Makes Ch3 the default knob position. Writes 1 to the device configured for Ch3,
writes 0 to the devices configured for the other channels.
Read from Destination Device:
The position of the knob is determined by the device value.
The default knob position is fixed for these two switch types because of the return functionality.
2-Notch R-return: Ch1
2-Note L-return, 3-Notch Both-return: Ch2
• If Default Position is Ch1, Ch2, or Ch3, the position of the knob does not change even if the value in
the device configured for the channel changes, unless the change is caused by the buttons on the
Selector Switch. If Default Position is Read from Destination Device, the position of the knob
changes according to the value of the device configured for the channel.
• When a Selector Switch is redisplayed immediately after switching the screen or when a hidden Selector
Switch is redisplayed, values are not written to the destination devices for the channels.
• If the value in the device used to determine the default knob position contains an illegal value, the knob
will be shown as follows:
- 2-Notch No-return: Ch1
- 3-Notch: Ch2