IDEC High Performance Series User Manual
Page 952
2 Text Groups and Text Configuration Procedure
19-4
WindO/I-NV2 User’s Manual
4
In Default Group, select the text group to use when the MICRO/I power is turned on and when switched to run
mode.
5
Select the Use Dynamic Text check box.
6
With Trigger Device, specify the word device to use as the condition to switch the text group.
Click
to display the Device Address Settings dialog box. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-67.
These options can only be configured when Number of Text Groups is specified as two or more.
7
Click OK to close the Text Group Settings dialog box.
This concludes creating text groups.
When the value of device is 0, the text group switches to the default group.
If the value of device is invalid, the text group is not switched.