IDEC High Performance Series - Manual (Page 1274)

2 USB Flash Drives
30-30 WindO/I-NV2 User’s Manual
4 Prepare the necessary files and store them on the USB flash drive or SD memory card.
If the necessary files are stored on an SD memory card, make sure to insert it into the MICRO/I before using it for
uploading or copying.
The necessary files are as follows.
• To download a project file
Create a project file (ZNV format).
For details, refer to Chapter 28 “1.3 Converting Project Data for Transfer” on page 28-3.
• To download an IDEC PLC program
Create a PLC program file (ZLD format).
For details, refer to Chapter 28 “2.4 Converting PLC Program Files for Transfer” on page 28-22.
• To copy files
Create the file to be copied.
Operating Procedure
1 Insert the USB flash drive into the MICRO/I.
The menu for the USB Autorun function appears.
Save
Computer
Project file
(ZNV format)
PLC program file
(ZLD format)
File
Copy files Only when downloading
SD Memory Card
USB flash drive
HG3G HG2G-5F HG4G
USB flash drive
MICRO/I
If the menu screen does not appear, follow these troubleshooting tips. Correct the problem and re-insert
the USB flash drive.
Cause: USB Autorun definition file (hgauto.ini) does not exist on the USB flash drive.
Correction: Create a USB Autorun definition file and save it on the USB flash drive. For details, refer to
“2.5 Creating a USB Autorun Definition File” on page 30-32.
Cause: The USB Autorun definition file (hgauto.ini) contains an error.
Correction: For details, refer to “2.5 Creating a USB Autorun Definition File” on page 30-32.
Cause: The USB Autorun function is disabled in the MICRO/I settings.
Correction: Enable the USB Autorun function by referring to Steps 1 and 2 on page 30-29.