IDEC High Performance Series - Manual (Page 155)

WindO/I-NV2 User’s Manual 3-53
5 User Communication
3
Communic
ation
Device
From the received data, data of the specified size is unconverted, or converted to binary format, and stored in the
device.
This can be configured only when RXD is selected in Command Type on the Command Settings dialog box, and
Device is selected under Type on the Data Settings dialog box.
■ Conversion Type
Select conversion processing for the received data from the following.
■ Device
Specify the word device for storing the received data. You can only specify an internal device.
Click to display the Device Address Settings dialog box. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-67.
■ Use Reference Device
To change the word device for storing the received data according to values of devices, select this check box and
specify a device. You can only specify an internal device.
Click to display the Device Address Settings dialog box. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-67.
■ Storage Method of data
Select the handling method for received data. This can be configured only when No Conversion is selected under
Conversion Type.
■ Number of bytes
Specify the received data size to be stored per word. The number of bytes to be specified varies based on
Conversion Type.
■ Words
Specify the number of word devices (1 to 250) for storing the received data.
ASCII (HEX) to Binary: Considers the received data as a hexadecimal number and converts it to binary data.
ASCII (DEC) to Binary: Considers the received data as a decimal number and converts it to binary data.
No conversion: No conversion is performed.
from Upper byte: Values of devices are stored from the upper byte.
from Lower byte: Values of devices are stored from the lower byte.
ASCII (HEX) to Binary: 1 to 4
ASCII (DEC) to Binary: 1 to 5
No Conversion: 1 to 2