IDEC High Performance Series - Manual (Page 1099)

WindO/I-NV2 User’s Manual 24-7
1 Communicating with the MICRO/I
24
Online F
unction
■ Port
Select the communication port on the computer from the following items.
■ Baud Rate
Select the communication speed for the serial port of the computer from the following items.
9600 bps, 19200 bps, 38400 bps, 57600 bps, 115200 bps
This can only be set when Serial is selected for Port or when Ethernet is selected for Port and the via Web
Server Unit check box is selected.
■ Time Out (min)
Specify the time to wait for a response from the MICRO/I (1 minute to 20 minutes).
*1 HG2G-S, HG1F/2F/2S/3F/4F only (This is applicable for HG2F models with Serial Interface 2 only.)
*2 HG2G-5S/-5F, HG3G/4G, HG2F only (This is applicable for HG2F models with USB interface only.)
*3 HG2G-S/-5S/-5F, HG3G/4G, HG3F/4F only
O/I Link Slaves: Communicate with an O/I Link Slave MICRO/I via an O/I Link Master.
For details, refer to “Using the online function with an O/I Link Slave via an O/I Link Master” on
page 24-9.
Memory Card: Read or write data to the external memory inserted in the computer.
For details, refer to Chapter 30 “1.4 Reading/Writing Data” on page 30-5.
O/I Link Communication
Computer
Serial cable
USB cable
Ethernet cable
MICRO/I
O/I Link Master
MICRO/I
O/I Link Slave
(Slave 15)
MICRO/I
O/I Link Slave
(Slave 2)
MICRO/I
O/I Link Slave
(Slave 1)
Read Write
Serial: Connect the serial port on the computer to Serial Interface 2 *1 on the MICRO/I.
(Serial port): Select from “COM 1” to “COM 256”.
USB: Connect the USB port on the computer to the USB interface *2 on the MICRO/I.
Ethernet: Connect the Ethernet port on the computer to the Ethernet interface
*3 on the MICRO/I.
via Web Server Unit: Ethernet communication is possible for MICRO/I types without an Ethernet
interface. This is with the use of the IDEC Web Server Unit (FC4A-SX5ES1E).
The USB interface is used for Maintenance Communication on the HG2G-5S. Select Serial for Port.
• The port number is 2537 when connecting from WindO/I-NV2 to the MICRO/I via Ethernet.
• The default network settings configured on the MICRO/I are as follows.
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0