IDEC High Performance Series - Manual (Page 525)

WindO/I-NV2 User’s Manual 10-13
1 Numerical Input
10
Data Displa
ys
■ When Data Over
These options configure the operation of the part when the value entered with the keypad exceeds the allowable
range.
These options can only be configured when the Minimum or Maximum check boxes are selected under Range.
Example: If you attempt to enter “140”, which is higher than the maximum of “100”, or “-10”, which is lower than the
minimum of “0”, the value is not written and “?” is displayed. 1 is written to When Data Over report device
LM 0.
Report: Select this check box to write 1 in the report device when the entered value or the value of the device
to display exceeds the allowable range.
Report Device: Specifies the report device.
Click to display the Device Address Settings dialog box. For the device
address configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on
page 2-67.
Operations
and
display
0
0
Entered data
80
80
80
?????
10
10
80
Written data
140
10
?????
10
80 10
-10
Data over notification: LM0 1 0 0 1
Range: Value
Minimum: 0
Maximum: 100
When Data Over
Report: On
Report device: LM0