2 hg1f/2f/2s/3f/4f, Hg1f/2f/2s/3f/4f -4 – IDEC High Performance Series User Manual
Page 906
2 Data Storage Area Configuration Procedure
16-4
WindO/I-NV2 User’s Manual
2.2 HG1F/2F/2S/3F/4F
1
On the Configuration tab, in the System Setup group, click Data Storage Area.
The Data Storage Area Management dialog box is displayed.
By default, the entire area is allocated into an area to save Alarm Log data and areas used as HG keep registers (LKR)
and HG keep relays (LK), so to change the allocation of memory, first you must change these areas.
2
Specify the amount of Alarm Log data to save in the data storage area in Number of Stored Data for Alarm Log
(0 to 1024).
3
Specify the number of HG keep register (LKR) addresses in Number of HG Keep Register (LKR) (1024 to 8192).
4
Specify the number of HG keep relay (LK) addresses in Number of HG Keep Relay (LK) (1024 to 8192).
5
Click OK.
The Data Storage Area Management dialog box closes.
This concludes configuring the data storage area.