IDEC High Performance Series - Manual (Page 809)

WindO/I-NV2 User’s Manual 13-11
2 Alarm Log Function Configuration Procedure
13
Alarm Log Function
This section describes the configuration procedure for the Alarm Log function.
2.1 Configuring the Devices to Monitor and the Alarm Detection Condition
1 On the Configuration tab, in the System Setup group, click Alarm Log.
The Alarm Log Settings dialog box is displayed.
2 Select the type of device to monitor under Source Device Type on the Channel tab.
If you select Word, devices are configured per block.
If you select Bit, devices are configured per channel.
3 Set the number of blocks to manage in Number of Blocks.
1 channel is used for 1 device to monitor. 1 block is 16 channels.
The number of blocks that can be set varies based on the Source Device Type setting and the MICRO/I model.
4 Select the reference screen type in Reference Screen.
The reference screen is associated with the channel. This screen is displayed when the key button Ref. is pressed.
If a reference screen is not displayed, select Not Use.
5 To batch register all channels, click Auto. To individually register each channel, click Edit.
An example when Auto is clicked is described here.
The Auto-Setup dialog box is displayed.
2 Alarm Log Function Configuration Procedure
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F