IDEC High Performance Series - Manual (Page 214)

3 Project Settings Dialog Box
4-28 WindO/I-NV2 User’s Manual
■ Enable Maintenance
Select this check box to display the maintenance screen during operation. The methods for displaying the
maintenance screen are as follows.
■ Use Large Font
Select this check box to display text on the MICRO/I in high-quality fonts. The Japanese or European font is
replaced with the high-quality fonts depending on the magnification.
To use high-quality fonts, the fonts must be downloaded to the MICRO/I at the same time as the project. To
download fonts, click Options in the Download dialog box to display the Options dialog box. Select the Download
additional fonts check box, select the check boxes of the high-quality fonts to use (Japanese large font (First
standard), Japanese large font (Second standard), European large font), and then click OK.
For details on high-quality fonts, refer to Chapter 2 “High-quality Fonts” on page 2-10.
■ Enable Two-point Push
Select this check box to enable two-point push for touch switches. When two-point push is enabled, the bottom
switch and the switch above it operate in order.
On an analog touch panel, this function operates two overlapping switches when the two are pressed. This is not a
function to simultaneously operate two touch switches when they are both pressed.
On the HG2F/2S/3F/4F, two switches can be turned on simultaneously.
■ Enable Low Battery Warning
Select this check box to display a warning when the backup battery is dead.
On the HG2G-S/5S/5F, the HG3G/4G, and the HG1F, this option also displays a warning when it is time to replace the
battery. The HG2G-5ST22VF-* does not have a backup battery, so this function cannot be used.
HG2G-S/-5S/-5F, HG3G/4G, HG1F: Press the upper-left corner of the MICRO/I screen for three seconds or
more.
If the base screen is switched before three seconds have elapsed, the
load operation for the maintenance screen will be canceled. Please
press the screen again.
HG2F/2S/3F/4F: Simultaneously press the upper-left and upper-right corners of the
MICRO/I screen.
Press and hold
3 or more seconds
MICRO/I
MICRO/I
On the HG2S with CC switches, two-point push for touch switches is not possible when a CC switch is
pressed.