IDEC High Performance Series - Manual (Page 1143)

WindO/I-NV2 User's Manual 25-17
1 Monitoring with WindO/I-NV2
25
Monitor F
unction
1.5 Switching the Screen of the MICRO/I
During monitoring, it is possible to switch to the screen displayed on the MICRO/I using a WindO/I-NV2 command.
■ (Back)
You are returned to the Base Screen that was displayed immediately before the screen was switched.
■ (Forward)
Advances to the Base Screen that was displayed immediately before the screen was switched using the (Back).
■ (First Screen)
Switches to the Base Screen with the lowest screen number in the project data.
■ (Previous Screen)
Switches to the Base Screen of screen number one lower than the Base Screen currently displayed. If the screen
numbers are not consecutive numbers, this command switches to the closest number.
■ (Specified Screen)
Switches to the Base Screen of a specified number.
■ (Next Screen)
Switches to the Base Screen of screen number one higher than the Base Screen currently displayed. If the screen
numbers are not consecutive numbers, switches to the closest number.
■ (Last Screen)
Switches to the Base Screen of highest screen number in the project data.
1.6 Open Current Screens
To automatically open the screen displayed on the MICRO/I during monitoring and put it into an active state, click
Open Current Screens.
1.7 Simulating Values of External Devices
To simulate values of external devices on the MICRO/I alone, after switching to monitor mode, on the Online tab, in
the Monitors group, click Start Simulation.
The MICRO/I switches to simulation mode and “Simulation Mode” flashes at the bottom left of the screen.