IDEC High Performance Series - Manual (Page 668)

10 Calendar
10-156 WindO/I-NV2 User’s Manual
●
Trigger Condition Tab
The Trigger Condition tab is displayed in Advanced mode.
The Calendar is enabled while the condition is satisfied, and it is disabled while the condition is not satisfied. When
disabled, the plate and flange are displayed, but the time is not displayed. For the HG2G-5F and the HG3G/4G, if the
Not show Calendar check box under While not satisfying the condition is selected, the plate and flange are
also hidden and the part image is not displayed.
■ Trigger Type
Selects the condition to enable the Calendar from the following.
Example: When Trigger Type is While ON, Device is LM 0, and the Not show Calendar check box under While
not satisfying the condition is cleared
While LM 0 is 0, the condition is not satisfied and the Calendar does not display the time.
While LM 0 is 1, the condition is satisfied and the Calendar displays the time.
LM0:
MICRO/I
0
LM0: 1
12/07 13:45
Condition
Not
satisfied
Condition
Satisfied
Show
time
Hide
time
Always visible: The Calendar is always enabled.
12/07 13:45
Always show time
Calendar state