IDEC High Performance Series - Manual (Page 1101)

WindO/I-NV2 User’s Manual 24-9
1 Communicating with the MICRO/I
24
Online F
unction
To execute any function except project data download
The Target IP Address dialog box will be displayed when any of the following functions are executed.
• Upload a project data.
• Upload data from an external memory inserted in the MICRO/I.
• Delete data stored in the internal memory.
• Delete data from or formatting an external memory inserted in the MICRO/I.
• Display information about runtime system and project data.
• Monitor the MICRO/I.
Specifies the IP address of the MICRO/I used for communication.
■ Target IP Address
Specify the IP address for the target MICRO/I to execute this function.
Click to display IP Address Manager. Specify the IP address for the target MICRO/I with IP Address Manager.
■ Port Number
Specify the port number (0 to 65535) of the Web Server Unit connected to the destination MICRO/I that will the
operational target.
This can only be set when Ethernet is selected for Port and the via Web Server Unit check box is selected in the
Communication Settings dialog box.
●
Using the online function with an O/I Link Slave via an O/I Link Master
Select O/I Link Slaves under Communicate with on the Communication Settings dialog box. For details about
O/I Link Communication, refer to Chapter 3 “2 O/I Link Communication” on page 3-3.
• When the MICRO/I used as an O/I Link Master or O/I Link Slave is connected with a computer, select
MICRO/I in the Communication Settings dialog box.
• The HG2G-S/-5S/-5F, the HG3G/4G, and the HG1F/2F/2S/3F/4F use different O/I Link Communication,
therefore they can not be connected on the same O/I Link Communication.
• During communication with an O/I Link Slave using the online function, O/I Link Master operation is
stopped.
• If the O/I Link Master is the HG1F/2F/3F/4F, the O/I Link Slave cannot be monitored.
• During the following states, maintenance communication is not possible via the O/I Link Master.
- The O/I Link Slave is in Simulation Mode.
- The HG1F is being used as the O/I Link Master.
To communicate with the O/I Link Slaves via the O/I Link Master, here are the conditions to follows.
• A project configured with the O/I Link Slave settings is being downloaded.
• The WindO/I-NV2 runtime system version is Ver. 2.5 or later.
• If the O/I Link Slave is the HG1F/2F/3F/4F, from the System Menu, under Initial Setting, O/I Link, set
to Use.