IDEC High Performance Series - Manual (Page 1062)

2 Security Function Configuration Procedure
23-12 WindO/I-NV2 User’s Manual
3 Click Add.
The New User Account dialog box is displayed.
4 Specify the user number (1 to 15) in No.
This number is used when switching the user account via the value of a device.
5 Enter the name for the new user in User Name.
The maximum number for the user name is 8 characters. Only alphanumeric characters and symbols can be used.
6 Enter the password in Password.
The number for the password is 4 to 15. Only uppercase alphabetic characters and numbers can be used.
7 Click the Group Membership tab.
Assign the security groups to the user being created.
Administrator, Operator, and Reader have already been provided in Security Group. These three security
groups cannot be used in multiple user accounts. To use them with the user account being created, delete the
security group from the user account they are assigned to beforehand.
If you will not add a new security group, proceed to step 11 .
If you will not assign a security group, proceed to step 12 .
You cannot use the following characters in the user name.
\ / : * ? “ < > |
Write down the password so you do not forget it and save that note in a safe place.
User3 User2 User1
Administrator Administrator Operator
Reader