IDEC High Performance Series - Manual (Page 852)

3 Data Log Settings Dialog Box
14-14 WindO/I-NV2 User’s Manual
■ Edit
Registers or changes the settings for the selected channel number.
Select a channel number and click this button to display the Individual Settings dialog box. The settings for the
selected channel are reflected in the Individual Settings dialog box.
For details, refer to “3.2 Individual Settings Dialog Box” on page 14-16.
■ Up
Shifts the selected settings upward in the list.
■ Down
Shifts the selected settings downward in the list.
■ Clear All Log Data *3 , Clear Log Data *4
Select this check box to erase the all log data saved in the data storage area.
■ Log to Data Storage Area *4
Select this check box to retain Data Log data even when the MICRO/I is turned off.
The amount of data that can be sampled per device is determined by the data storage area settings used by the Data
Log data storage amount and the HG keep register (LKR) and HG keep relay (LK) addresses.
The data storage amount per device is calculated as shown next.
Data storage amount per device =
(Data storage area capacity (18560) - (Data log data storage amount × 16 + HG keep register addresses × 2
+ ((HG keep relay addresses + 15) ч 16) Ч 2)) ч (6 Ч Number of used channels + 2 × Amount of used data)
Example: When the Data Log data storage amount is 500, the HG keep register addresses (LKR) are 1024,
the HG keep relay addresses (LK) are 1024, the channels used by the Data Log are 2, and the amount of
data used is 2:
The data storage amount per device is
(18560 - 16 Ч 500 + 1024 Ч 2 + ((1024 + 15) ч 16) Ч 2)) ч (6 Ч 2 + 2 Ч 2) = 524
If this check box is cleared, the data storage amount per device automatically becomes 1024.
*2 Advanced mode only
*3 HG2G-S/-5S/-5F, HG3G/4G only
*4 HG1F/2F/2S/3F/4F only
Monitor: Shows the write destination device for the amount of data when monitoring the amount of
sampled data. Shows No when not monitoring. Double clicking the cell displays the Individual
Settings dialog box where you can edit the settings. For details, refer to “3.2 Individual
Settings Dialog Box” on page 14-16. This option can only be set when Enable is selected in Log
Function.
Batch: Shows the trigger device that triggers batch output when batch outputting all the data saved in
the data storage area to the memory card. Shows No when there is no batch output. Double
clicking the cell displays the Individual Settings dialog box where you can edit the settings.
For details, refer to “3.2 Individual Settings Dialog Box” on page 14-16.
Real Time: Shows whether or not to perform real time output. Double clicking the cell switches between
Yes and No. Data is output to the memory card in 3 minute intervals for Yes channels. This
option can only be set when Enable is selected in Log Function.
No. of Data *2 : Shows the number of devices to sample in one channel. Double clicking the cell displays the
Individual Settings dialog box where you can edit the settings. For details, refer to “3.2
Individual Settings Dialog Box” on page 14-16. This option can only be set when Enable is
selected in Log Function.
(Trigger device): Specifies the bit device or bit of the word device that triggers the erasure of the data. The data
for all channels is erased when the value of the configured device changes from 0 to 1. For the
device address configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page
2-67.