IDEC High Performance Series - Manual (Page 880)

4 Using the Data
14-42 WindO/I-NV2 User’s Manual
25 Specify the source device for the copied data in Display Device under Display Method.
For sequential devices of the amount of data to copy starting with Destination Device configured on the Options
tab on the Data Log Settings Individual Settings dialog box, set Display Device for each Numerical Display to
those devices.
Example: When Destination Device is LDR 10, Number of Data is 3
Specify three Numerical Displays with Display Device specified as LDR 10, LDR 11, LDR 12
Click to display the Device Address Settings dialog box. For the device address configuration procedure, refer
to Chapter 2 “5.1 Device Address Settings” on page 2-67.
26 Click OK.
The Properties dialog box closes.
27 Repeat step 17 through 26 to configure the Numerical Displays for the amount of data to copy.
This concludes configuring the Numerical Display.
HG3G HG2G-5F
HG2G-5S HG2G-S
HG4G
MICRO/I
Host
(Internal device)
124
125
126
Data Log data
Sampling Time Data001
01/01/2011 12:00:30 120
01/01/2011 12:01:30 121
01/01/2011 12:02:30 122
01/01/2011 12:03:30 123
01/01/2011 12:04:30 124
01/01/2011 12:05:30 125
01/01/2011 12:06:30 126
LDR10 : 126
LDR11 : 125
LDR12 : 124
Copy