IDEC High Performance Series - Manual (Page 134)

5 User Communication
3-32 WindO/I-NV2 User’s Manual
■ Transmission Wait (x100 msec)
Specify the wait time (0 to 255) from when the trigger condition is satisfied to when the data is transmitted. This can
be configured only when TXD is selected in Command Type on the Command Settings dialog box.
After the Transmission Wait duration has elapsed from when the trigger condition is satisfied, transmission starts.
Example: When Trigger Type in Trigger Condition is Rising-edge and Device is LM100
■ Receiving Time Out (x100 msec)
Set the time out (0 to 255) from when the trigger condition is satisfied to when 1 frame of data has been received. A
frame refers to a data string from the beginning to the end of a command. If the Receiving Character Time Out is set
to 0, it is not monitored.
This can be configured only when RXD is selected in Command Type, and While ON, While OFF, or While
satisfying the condition is selected in Trigger Type.
When 1 frame of data could not be received, even though the Receiving Time Out duration has elapsed from when
the trigger condition is satisfied, the value of the Receiving Time Out of the Status Device (address+0, bit 14)
changes to 1. When the Receiving Time Out duration elapses, the value of the Completed Device does not change to
1, and the receive data is not processed.
When the trigger condition again changes from not satisfied to satisfied, the value of the Receiving Time Out of the
Status Device (address+0, bit 14) changes to 0. When the value of this bit is not 0, the Receiving Time Out cannot be
detected.
Example: When Trigger Type in Trigger Condition is While ON, Device is LM100, Status Device is LDR110,
Completed Device is LM101 and the Not Clear Completed Device automatically check box is not
selected
When Status Device is LDR110, error information and time out information is stored in each bit of
LDR110.
When receiving of 1 frame of data is completed before the Receiving Time Out duration has elapsed from
when the trigger condition is satisfied, the value of the Receiving Time Out of the Status Device LDR110
(address+0, bit 14) remains 0.
Transmission command
Value of LM100 when
Trigger Condition is
Rising-edge
1
0
Transmission data 1 frame
Transmission
Wait duration
Transmission data 1 frame
Transmission
Wait duration
Value of Device when
Trigger Condition is
While ON
1
0
1
0
Receiving Time Out duration
Value of the Receiving Time Out
(address+0, bit14)
of the Status Device
Receive command
Value of LM100 when
Trigger Condition is While ON
1
0
1
0
Value of Completed Device LM101
1
0
Receive data 1 frame
Receiving Time Out duration
Receive data 1 frame
Value of Receiving Time Out
(address+0, bit 14)
of Status Device LDR110