IDEC High Performance Series - Manual (Page 238)

3 Project Settings Dialog Box
4-52 WindO/I-NV2 User’s Manual
■ Protocol
Shows the protocol defined as the selected user communication. For details, refer to Chapter 3 “Command Settings
Dialog Box” on page 3-27.
■ Command
Shows the command settings for the selected protocol. Double clicking the cell displays the Data Settings dialog
box. For details, refer to Chapter 3 “Data Settings Dialog Box” on page 3-37.
No.: Shows the number for managing the protocol settings. Double clicking the cell displays the
Command Settings dialog box.
Type: Shows the type of command. Double clicking the cell displays the Command Settings dialog
box.
Completed: Shows the send/receive complete report device. Double clicking the cell displays the Command
Settings dialog box.
Status: Shows the destination device for the send/receive size and error information. Double clicking the
cell displays the Command Settings dialog box.
Trigger Type: Shows the trigger type to transmit or receive data. Double clicking the cell displays the
Command Settings dialog box.
Trigger Condition: The displayed content varies based on Trigger Type.
Rising-edge, Falling-edge, While ON, or While OFF: Shows the bit device that is the
condition. Double clicking the cell
displays the Command Settings
dialog box.
While satisfying the condition or Satisfy the condition: Shows the conditional expression.
Fixed Period: Shows the period in seconds.
Comment: Shows the command comment. Double clicking the cell displays the Command Settings dialog
box.
Size: Shows the command size in bytes. Double clicking the cell displays the Command Settings
dialog box.