IDEC High Performance Series - Manual (Page 128)

5 User Communication
3-26 WindO/I-NV2 User’s Manual
■ Copy
Copies the selected command.
Click this button to copy the selected command and add it to the end of the Protocol List.
■ Command
Displays data of the command selected in the protocol. Double clicking the line displays the Data Settings dialog box.
■ Copy to Protocol Manager
Copies a user communication protocol during editing and copies it to Protocol Manager.
Click this button to copy the user communication protocol and add it to the Protocol List of Protocol Manager.
This is enabled only when the User Communication Protocol Settings dialog box under the User Communication
tab on the Project Settings dialog box is displayed.
When a protocol of the same name has already been saved, an overwrite confirmation message is displayed.
Click Overwrite to overwrite the existing protocol.
Click Rename to display the Protocol File Name Settings dialog box. Enter a new protocol name, and then click OK to
save the protocol.
Click Cancel to stop saving the protocol.
■ OK
Adds or changes the user communication protocol and closes the User Communication Protocol Settings dialog box.
When a protocol of the same name has already been saved, an overwrite confirmation message is displayed.
Click Overwrite to overwrite the existing protocol.
Click Rename to display the Protocol File Name Settings dialog box. Enter a new protocol name, and then click OK to
save the protocol.
Click Cancel to stop saving the protocol.
■ Cancel
Closes the User Communication Protocol Settings dialog box, without adding or changing the user communication
protocol.
Protocol File Name Setting Dialog Box
Specify the name of a user communication protocol.
■ Protocol File Name
Enter the name of the user communication protocol. The maximum number for protocol name is 40 characters.
The User Communication Protocol Settings dialog box under the User Communication tab on the Project
Settings dialog box can be displayed in the following ways.
• Click Edit.
• Click Browse, and then click Add or Edit in Protocol Manager.
You cannot use the following characters in the protocol name.
\ / : , ; * ? " < > |