IDEC High Performance Series - Manual (Page 120)

5 User Communication
3-18 WindO/I-NV2 User’s Manual
26 Specify the data, and then click OK.
The data configured in Command on the Command Settings dialog box is displayed.
27 Repeat steps 24 through 26 to specify all the data for the receive command.
28 Click OK.
The receive command configured in Protocol on the User Communication Protocol Settings dialog box is displayed.
To add a transmission command, repeat steps
5 through 16 .
To add a receive command, repeat steps 17 through 28 .
29 Configure all commands, click OK.
User communication protocols are registered in Protocol List on Protocol Manager.
The data are displayed in Command in the order they were set. To change the order of data, select data,
and then click Up or Down to shift it.