Pr ev entiv e mainte nanc e function – IDEC High Performance Series User Manual
Page 923
WindO/I-NV2 User’s Manual
17-15
4 Using the Data
17
Pr
ev
entiv
e Mainte
nanc
e Function
7
Select the Report when Operation Time has reached or exceeded Threshold level check box.
8
Select the type of data for the threshold.
If you select Value, specify the threshold as a constant.
If you select Device, specify the threshold as a device value.
9
Configure Threshold for level 1.
When you select Value as the threshold data type, specify the threshold as a constant. The range for the constant
that can be set varies based on the data type.
When you select Device as the threshold data type, specify the threshold as a device value. Click
to display the
Device Address Settings dialog box. For the device address configuration procedure, refer to Chapter 2 “5.1 Device
Address Settings” on page 2-67.
10
Configure Report Device for level 1.
Specify the bit device or bit of the word device for reporting when the threshold is reached or exceeded. Click
to
display the Device Address Settings dialog box. For the device address configuration procedure, refer to Chapter 2
“5.1 Device Address Settings” on page 2-67.
You can only specify an internal device.
11
Click OK to close the Individual Settings dialog box.
You are returned to the Preventive Maintenance Settings dialog box.
12
Click OK.
The Preventive Maintenance Settings dialog box closes.
13
On the Configuration tab, in the System Setup group, click Alarm Log.
The Alarm Log Settings dialog box is displayed.