IDEC High Performance Series - Manual (Page 788)

6 Multi-Command
12-52 WindO/I-NV2 User’s Manual
If Upload PLC Program is selected.
■ Recording Target *5
The recording of images and sound starts. Select the target to record out of the signals input from the device.
*5 This is applicable for models with a video interface only.
Source: Specify the source PLC connected to the MICRO/I. The setting varies based on the driver selected for
Host I/F Driver.
OpenNet,MicroSmart,SmartAXIS Pro/Lite(RS232C/485):
Network Number: Specify the network number of the source PLC.
OpenNet,MicroSmart,SmartAXIS Pro/Lite(Ethernet):
Select from the following method:
Specify Station Number: Specify the station number (0 to 31) of the source PLC. This is
the station number set in the Project Settings dialog box, on
the Host I/F Network tab. For 1:1 communication, this is 0.
Specify IP Address: Specify the IP address and port number of the source PLC.
Destination: Specify where to save the PLC program uploaded from the PLC connected to the MICRO/I. Select the
type of external memory: SD Memory Card or USB Flash Drive.
Folder Path: Specify the path to the folder where the uploaded PLC program file will be saved. The
maximum number is 247 characters.
Example: To save it to the folder “Uploaded_Program” on an SD memory card or USB
flash drive:
Uploaded_Program
Video and Audio: Records images and sound.
Video only (No Audio): Records images only.
• Movie files cannot be recorded during playback.
• While data is being recorded after an event occurs with the event recording function and while data is
being saved to the memory card, recording cannot be executed with parts. Also, during these situations,
the value of HG special internal register LSD155-0 changes to 1. For details, refer to Chapter 32 “HG
Special Registers (LSD)” on page 32-5.