IDEC High Performance Series - Manual (Page 1107)

WindO/I-NV2 User’s Manual 24-15
2 Downloading
24
Online F
unction
5 Click Download.
• When Communicate with is set to MICRO/I and Port to USB or Serial, the project data starts downloading.
• When Communicate with is set to MICRO/I and Port to Ethernet, the Target IP Address dialog box is
displayed. Specify the IP address of the MICRO/I, and then click OK to start the download. For details, refer to “To
download project data” on page 24-8.
• When Communicate with is set to O/I Link Slave, the Target Slave dialog box is displayed. Specify the slave
station number of the MICRO/I to download to, then click OK to start the download.
If Port is set to Ethernet, specify the IP address of the O/I Link Master via which to download. If Port is
Ethernet and the via Web Server Unit check box is selected, specify the port number of the Web Server Unit
connected to the destination MICRO/I. For details, refer to “To download project data” on page 24-10.
6 Click Yes.
The Download Project dialog box is displayed and the project file starts downloading.
When finished downloading, a completion message is displayed.
7 Click OK.
8 Click Close on the Download Project dialog box.
This concludes downloading project data.
If security is enabled in the MICRO/I project, the Password Screen is displayed. Enter the password.
For details, refer to Chapter 23 “User Accounts and the Security Function” on page 23-1.
• Do not turn off the MICRO/I while project data is downloading.
• If project data downloading fails and communication is not possible, turn the MICRO/I off and on, then
download the data once again.
• During communication with an O/I Link Slave using the online function, O/I Link Master operation is
stopped.
For details on writing project data to an external memory inserted in the computer, refer to Chapter 30
“Downloading” on page 30-10.