IDEC High Performance Series - Manual (Page 674)

1 Bar Chart
11-2 WindO/I-NV2 User’s Manual
1.2 Bar Chart Configuration Procedure
This section describes the configuration procedure for bar charts.
1 On the Home tab, in the Parts group, click Charts, and then click Bar Chart.
2 Click a point on the edit screen where you wish to place the Bar Chart.
3 Double-click the dropped Bar Chart and a Properties dialog box will be displayed.
4 Change the settings on each tab as necessary.
The Data Over tab, Scale tab, Label tab, Trigger Condition tab and Options tab only appear in
Advanced mode.
To switch to Advanced mode, click Advanced.