IDEC High Performance Series - Manual (Page 976)

3 Global Script
20-12 WindO/I-NV2 User’s Manual
A Global Script operates for the entire project. The amount that can be set to Global Script actions and the project are
as follows.
3.1 Setting procedures for Global Script
Global Script is setup using the following procedures.
1 On the Configuration tab, in the System Setup group, click Global Script.
The Global Script Settings dialog box (HG2G-S/-5S/-5F, HG3G/4G) or the Global Script dialog box (HG1F/2F/2S/
3F/4F) is displayed. For the HG1F/2F/2S/3F/4F, proceed to step
3 .
2 Under Settings, select the script ID to configure, and then click Edit.
The Global Script dialog box is displayed.
3 On the General tab, select the Use Global Script check box.
4 Specify the script ID (1 to 32,000) of the script to execute.
The Script Manager is displayed when the button is clicked. The script can be selected from the script list of the
Script Manager. For details, refer to “2.2 Script Manager” on page 20-7.
3 Global Script
HG2G‐S/‐5S/‐5F, HG3G/4G: The scripts are executed in order on the list and in accordance with the trigger
conditions at the end of MICRO/I scan process. A maximum of 16 scripts can be
set to a project.
HG1F/2F/3F/4F: The script is executed in accordance with the trigger conditions at the end of
MICRO/I scan process. A maximum of only one script can be set to a project.
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
With Global Script, you cannot do indirect read and indirect write of the external device address.
For details about the indirect read and indirect write, refer to Chapter 2 “Indirect Read and Indirect Write
Settings” on page 2-5.