IDEC High Performance Series - Manual (Page 1038)

2 Multimedia Function Configuration Procedure
22-6 WindO/I-NV2 User’s Manual
2.2 Configuring the Event Recording Function
1 On the Configuration tab, in the System Setup group, click Multimedia.
The Multimedia Settings dialog box is displayed.
2 Click the Record tab.
3 Select the Use Event Recording check box.
4 Select Video and Audio or Video only (No Audio) as the target to record out of the signals input from the device.
5 Specify the bit device that will trigger the start of recording in Trigger Device.
Click to display the Device Address Settings dialog box. For the device address configuration procedure, refer
to Chapter 2 “5.1 Device Address Settings” on page 2-67.
6 Specify the recording time before and after the event occurs.
■ Recording Time Before Event(sec)
With the point in time when the trigger device value changes from 0 to 1 as the start point, this setting specifies how
many seconds to record before the start point (1 to 15 sec.).
■ Recording Time After Event(sec)
Specifies the time (1 to 15 sec.) until recording stops from when the trigger device changed from 0 to 1.
7 Click OK.
The Multimedia Settings dialog box closes.
This concludes configuring the Record function.