Yaskawa Sigma II Series Servo System - Manual (Page 276)

Sigma II User’s Manual Chapter 7: Using the Digital Operator
7 - 2
7.1 Basic Operation
This section provides information on the basic operation of the digital operator for setting
operating conditions.
7.1.1 Connecting the Digital Operator
There are two types of digital operators. One is a built-in operator incorporating a
panel indicator and switches located on the front panel of the servo amplifier. This
type of digital operator is also called a panel operator. The other one is a hand-held
operator (i.e., the JUSP-OP02A-1 digital operator), which can be connected to the
servo amplifier through connector CN3 of the servo amplifier.
There is no need to turn OFF the servo amplifier to connect this hand-held operator
to the servo amplifier. Refer to the following illustrations to connect the hand-held
digital operator to the servo amplifier.
Note: If the hand-held digital operator is connected to the servo amplifier, the built-in panel operator does
not display anything.
YASKAWA 200V
MODE/SET DATA/ SERVOPACK
ALARM
RESET
DIGITAL
OPERATOR
JUSP-OP02A-1
DSPL
SET
DATA
ENTER
JOG
SVON
YASKAWA
Hand-held Digital Operator
JUSP-OP02A-1 Built-in Panel Operator
CN3
Servo Amplifier
A single-purpose cable
(JZSP-CMS00-1) is
used to connect the
SGDH-
SERVOPACK
servo amplifier.
digital operator to the