Using the built-in panel operator – Yaskawa Sigma II Series Servo System User Manual
Page 324
Sigma II User’s Manual
Chapter 7: Using the Digital Operator
7 - 50
4.
Press the DSPL/SET key. The display will change as shown below and offset
will be automatically adjusted.
5.
Press the DATA/ENTER key to return to the auxiliary function mode display.
This completes the automatic adjustment of the motor current detection offset.
Using the Built-in Panel Operator
1.
Press the MODE/SET key to select the auxiliary function mode.
2.
Press the Up Arrow or Down Arrow key to select the parameter Fn00E.
3.
Press the DATA/SHIFT key for a minimum of one second, and the display will
be as shown below.
4.
Press the MODE/SET key. The display will change as shown below and the
offset will be automatically adjusted.
5.
Press the DATA/SHIFT key for a minimum of one second to return to the
auxiliary function mode display.
This completes the automatic adjustment of the motor current detection offset.
Flashing
for one
second
SGDM-
MODE/SET
DATA/
CHARGE
POWER
SERVOPACK
200V
YASKAWA
Flashing
for one
second