Yaskawa Sigma II Series Servo System - Manual (Page 297)

Sigma II User’s Manual Chapter 7: Using the Digital Operator
7 - 23
Mode and 5.3.2 JOG Speed.
Operation procedure using the digital operator is described on the following pages.
Using the Hand-held Digital Operator
1. Press the DSPL/SET key to select Fn002 in the auxiliary function mode.
2. Press the DATA/ENTER key to select the digital operator operation mode.
Operation is now possible using the digital operator.
3. Press the SVON key to set to the servo ON state (with motor power turned ON).
4. Press the Up Arrow or Down Arrow key to operate the motor. The motor
keeps operating while the key is pressed.
5. Press the MODE/SET key, and the display will revert to Fn002. This sets to the
servo OFF state (with motor power turned OFF). Alternatively, press the SVON
Key to set to the servo OFF state.
This ends JOG operation under digital operator control.
C
N
3
C
N
1 L1C
L2C
B1
B2
U
V
W
L1
L2
1
2
C
N
2
SGDH-
MODE/SET DATA/
CHARGE POWER
SERVOPaCK
200V YASKAWA
Power
Servo amplifier
Servomotor
Panel
Operator
Motor Forward
Rotation
Motor Reverse
Rotation