Dell PowerEdge M805 - Manual (Page 106)

68 Using the CLI
www
.dell.com | support.dell.com
Would you like to run the set up wizard (you must answer this
question within 60 seconds)? [Y/N] y<Return>
Step 1:
The system is not configured for SNMP management by default. To
manage the switch using SNMP (required for Dell Network Manager)
you can
o Setup the initial SNMP version 1 & 2 now.
o Return later and setup other SNMP accounts (for more information
on setting up an SNMP version 3 account, see the user
documentation).
Would you like to configure the SNMP management interface now?
[Y/N] y<Return>
To configure the SNMP management account you must specify the
management system IP address and the "community string" or
password that the particular management system uses to access the
switch. The wizard automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell Network
Manager or other management interfaces to change this setting and
to add additional management systems later. For more information
on adding management systems, see the user documentation.
To add a management station:
Type the SNMP community string to be used [public]:
Dell_Network_Manager <Return>
NOTE: If it is configured, the default access level is set to the
highest available access for the SNMP management interface.
Initially only SNMPv1/2c will be activated. SNMPv3 is disabled
until you return to configure security access for SNMPv3 (e.g.
engine ID, view, etc.).
Type the IP address of the Management System (A.B.C.D) or wildcard
(0.0.0.0) to manage from any Management Station [0.0.0.0]:
192.168.1.10 <Return>
Step 2: